NXP公司的TEA152x系列STARplug是開關電源(SMPS)控制器,能直接連接到火線整流后的高壓.器件采用高壓EZ-HV SOI工藝和低壓雙極互補MOS(BiCMOS)工藝制造,集成了650V高壓開關,火線工作電壓從80 V到276 V,可提供的功率高達30W,有廣泛的用途,包括充電器,適配器,STB,DVD,TV/監(jiān)視器電源,PC外設和MCU電源等.本文介紹了TEA152x主要特性和優(yōu)勢,方框圖,多種應用和STARbuck評估板主要特性,電路圖和所用元器件.
TEA152x: SMPS ICs for low-power systems
The TEA152x family STARplug is a Switched Mode Power Supply (SMPS) controller IC that operates directly from the rectified universal mains. It is implemented in the high-voltage EZ-HV SOI process, combined with a low-voltage Bipolar Complementary Metal-Oxide Semiconductor (BiCMOS) process.
The device includes a high-voltage power switch and a circuit for start-up directly from the rectified mains voltage. A dedicated circuit for valley switching is built in, which makes a very efficient slim-line electronic power-plug concept possible.In its most basic version of application, the TEA152x family acts as a voltage source.Here, no additional secondary electronics are required. A combined voltage and current source can be realized with minimum costs for external components. Implementation of the TEA152x family renders an efficient and low cost power supply system.
TEA152x主要特性和優(yōu)勢:
Designed for general purpose supplies up to 30 W
Integrated power switch:
TEA1520x: 48 Ω; 650 V
TEA1521x: 24 Ω; 650 V
TEA1522x: 12 Ω; 650 V
TEA1523P: 6.5 Ω; 650 V
Operates from universal AC mains supplies (80 V to 276 V)
Adjustable frequency for flexible design
RC oscillator for load insensitive regulation loop constant
Valley switching for minimum switch-on loss
Frequency reduction at low power output makes low standby power possible(< 100 mW)
Adjustable overcurrent protection
Undervoltage protection
Temperature protection
Short-circuit winding protection
Simple application with both primary and secondary (opto) feedback
Available in DIP8 and SO14 packages
TEA152x應用:
Chargers
Adapters
Set-Top Box (STB)
DVD
CD(R)
TV/monitor standby supplies
PC peripherals
Microcontroller supplies in home applications and small portable equipment, etc.
圖1.TEA152x方框圖
圖2.TEA152xP(DIP8)初級檢測應用電路圖
STARbuck評估板
The NXP Semiconductors STARbuck demo board is a flexible, user configurable, non-isolated SMPS application intended for low power loads.
STARbuck has a universal mains input and a single positive or negative DC voltage output.This manual describes the STARbuck demo board version 1.0.
Refer to the TEA152x data sheet for details on the STARplug device and the STARplug application note AN00055 for general application information.
The STARbuck Switched Mode Power Supply (SMPS) demo board has one single non-isolated DC output voltage. The circuit is built around an NXP Semiconductors STARplug IC and the operation mode of the circuit is either buck or buck/boost.
The default configuration on the STARbuck demo Printed-Circuit Board (PCB) implements Buck mode operation and produces 5 V (DC) (100 mA maximum) on the output terminals.However, by changing the jumper settings, modifying the component values, or swapping the components, the STARbuck demo board can be adapted easily to meet specific needs with respect to the output voltage and the output current.
STARbuck評估板主要特性:
• Universal mains input
• Single DC voltage output
• Non-isolated, AC mains supply Neutral terminal connected to 0 V (GND) DC output terminal
• Produces either a positive polarity in Buck mode or a negative polarity voltage in Buck/boost mode
• No custom-made magnetic components required; uses only standard components
• User configurable output voltage range between 5 V and 36 V
• User configurable maximum output current set using resistor R3:
– TEA1520T: up to 125 mA; maximum output power < 2.5 W
– TEA1521T: up to 250 mA; maximum output power < 5 W
– TEA1522T: up to 500 mA; maximum output power < 10 W
• High efficiency (at higher output voltages only):
– TEA1520T: 12 V; 1 W; typical efficiency > 75 %
– TEA1522T: 12 V; 4 W; typical efficiency > 78 %
• Very low standby (no-load) power (at higher output voltages only):
– TEA1520T: 12 V; 1 W; typical standby power < 40 mW
– TEA1522T: 12 V; 4 W; typical standby power < 65 mW
• Overload protection
• OverTemperature Protection (OTP)
• Built-in ElectroMagnetic Interference (EMI) filter
圖3.STARbuck評估板外形圖
圖4.TEA152x應用電路圖:+5V輸出,降壓模式
圖5.TEA152x應用電路圖:-5V輸出,降壓/升壓模式
圖6.TEA152x帶外接VCC應用電路圖:12V輸出,降壓模式
圖7.TEA152x VCC尖峰保護應用電路圖:12V輸出,降壓模式
圖8.TEA152x帶降低EMI濾波器的應用電路圖
默認元件列表:
降壓/升壓轉換器增加元件列表:
外接電源VCC元件列表:
帶尖峰保護外接電源VCC元件列表:
降低EMI濾波器元件列表:
詳情請見:
http://www.nxp.com/documents/data_sheet/TEA152X.pdf
和
http://www.nxp.com/documents/user_manual/UM10371.pdf
